Dodge Avenger Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1 (Edited)
on my 2008 dodger avenger, the valve body shaft was rusted, and ceased in my transmission, causing it to break my shiftier, and transmission cable. Both were replaced, and the valve body dropped from the transmission.

While lowering the valve body, I had discovered a few springs and clips on top of the body, and have absolutely no idea where they are from.

If anybody can help to identify these parts, and their original locations it would be greatly appreciated!

Thanks for your time.

IMG_2583.JPG IMG_2588.JPG IMG_2589.JPG


Transmission 41TE
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Welcome to the forum! Maybe this diagram will help???:
http://www.makcotransmissionparts.com/mm5/graphics/Catalog-pdf/A604.pdf
Also check on Google images for an exploded view of the 41TE.
Thanks for the help, unfortunately i have already referred to this schematic, and have had no luck :\
I think these items may be from the valve body itself, but I can't seem to find any information on that.

If you had any information, or a schematic of the valve body itself that would be very appreciated.

Thanks so much for your time, and effort
 

Attachments

1 - 4 of 4 Posts
Top