Dodge Avenger Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have to swap out my drivers side door and i.need the locks cylinder and door handle from the old 1 and put it on the new door i.have looked on YouTube and can't find anything on how to remove these 2 things can someone point me in the right direction
 

·
Registered
Joined
·
3,142 Posts
Front door outside handle

Raise the window to the full up position
Remove door trim panel
Disconnect the latch rods from the door handle and lock cylinder - pry the end of the lock and handle rod retaining clips up and pull the rods out of the handle.
Remove the fasteners securing the door handle to the outer door panel and remove the handle from the vehicle

Installation is in reverse
 

·
Registered
Joined
·
3,142 Posts
Sorry, 2 more steps

Through the access hole remove the handle front mounting fastener
Then peel the tape back and working through the access hole, remove the handle front mounting fastener


Yes, makes no sense, but that's what my book says
 
1 - 3 of 3 Posts
Top