Dodge Avenger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
Hi, this is Vince2008. My 2008 Avenger 2.7 , 6 cylinder, check engine light, and the ETC light came on yesterday. But the car runs the same. Just a little hesitation on acceleration at first, then it runs normally. But both check engine light and ETC bolt still come on. What can be the problem? I'd appreciate any suggestions.Thanks.
 

·
Registered
Joined
·
4,640 Posts
Hi Vince, sounds like you may have an issue with your throttle body. Might just need a good clean with SeaFoam spray or it could be wearing out. Have you read the code with a scanner? Sometimes it could be a one time glitch, if you reset the code it may not come back.
 
1 - 2 of 2 Posts
Top