Dodge Avenger Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
could anyone tell me how to disable my seatbelt alarm on a 2008 avenger i cant seem to find my book thanks
 

·
Registered
Joined
·
3,679 Posts
Disable BeltAlert (Seat Belt Chimes):
NOTE: The following steps must occur within the first
60 seconds of the ignition switch being turned to the ON
or START position. DaimlerChrysler does not recommend
deactivating Beltalert.
1. Turn the ignition switch to the LOCK position and
buckle the driver’s seat belt.
2. Turn the ignition switch to the ON position and wait
for the Seat Belt Warning Light to turn off.
3. Within 60 seconds of turning the ignition switch to the
ON position, unbuckle and then re-buckle the driver’s
seat belt at least three times within 10 seconds, ending
with the seat belt buckled.
NOTE: Watch for the Seat Belt Warning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt partially each
time when unbuckling.
4. Turn the ignition switch to the LOCK position. A
single chime will sound to signify that you have successfully
completed the programming.

For more information:
http://www.avengerforumz.com/showthread.php?t=43828
 

·
Registered
Joined
·
348 Posts
ive always just thought of buckling it and then sitting in front of it i would do it if i were still a civilian but army's too strict when it comes to driving, like 35 is the fastest i can go on base and only on a few roads! such a waste of my avenger :( and then i would hear it from the wife too ughhhhhhhhhh too much problems just to not buckle lol
 

·
Registered
Joined
·
118 Posts
Kind of surprised that I got the chime disabled on Our 2011 Avenger Heat, that as far as I know, Does have the EVIC system.
It took a couple of tries and I had to have the engine running ( not at all sure why it had to be running)....It IS Nice to be able to drive the short distance to Our place after stopping to p/u the mail and not have the chime be ringing...the seatbelt light still is on when the belt is unbuckled.
Next is to see if I can get the driver's side window to do a "1-touch Up" operation!!
Doc
 

·
Registered
Joined
·
3,881 Posts
Which OBD interface do you use to hook up to the car with the DiagFCA, Vgate iCar2 bluetooth ?
 
1 - 10 of 10 Posts
Top