Dodge Avenger Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
On front passenger side window went down fine no stopping, or jerking, or anything. Then yesterday evening i went to raise it nothing i took off door pannel and cleaned switch still nothing did not take off motor as i can hear it clicking so that may not be the problem and looking at the wiring this more than I would want to do myself I need some suggestions as how I can get window up until I take it to shop
 

·
Registered
Joined
·
3,867 Posts
Since you hear the motor clicking it could be the regulator that needs replacement. There are lots of threads on this subject on the site.
 

·
Registered
Joined
·
35 Posts
Discussion Starter #5
Yea got the door busted down and everything off just can't get the New regulator on the window so I'm going to try again in the morning if not I would drop it off at a shop Monday but other than back it was fairly easy after reading one of the threads in watching several YouTube videos
 

·
Registered
Joined
·
3,867 Posts
Maybe this will help, it's for a 2008 but they should be the same.
18821

WINDOW REGULATOR

  1. Position regulator on carrier plate and install the screws (1).
  2. Install window motor and screws (2)
  3. Install carrier plate
  4. Connect power window motor wire electrical connector.
  5. Reattach glass
  6. Install door trim panel
  7. Perform the Clear/Relearn procedure.
 
1 - 7 of 7 Posts
Top