Removing Arm Rest/Cup Holder Console | Dodge Avenger Forum

Removing Arm Rest/Cup Holder Console

Discussion in 'Detailing and General Maintenance Forum' started by moparman1984, May 2, 2018.

  1. moparman1984

    moparman1984 New Member

    Joined:
    May 2, 2018
    Messages:
    1
    Likes Received:
    0
    Gender:
    Male
    Location:
    Canada
    Howdy everyone,

    I am in the middle of removing the arm rest/cup holder console from my 08 Avenger due to the previous owner leaving it FILTHY. I removed all bolts and it's currently loose. The problem I face however is even with the parking brake pulled to it's max, it's still not enough to pull the console up over.

    Any tips or tricks?

    Thanks!!
     
  2. Intrepid

    Intrepid Active Member MOTM Winner!

    Joined:
    Jan 11, 2013
    Messages:
    3,156
    Media:
    10
    Likes Received:
    314
    According to Alldata:

    008 Dodge Avenger L4-2.4L Copyright © 2013, ALLDATA 10.52SS Page 1
    Console: Service and Repair
    Center Console Shifter Housing - Removal
    REMOVAL
    AVENGER
    1.Remove console bezel.See: Center Console Bezel - Removal.
    2.Remove shift knob and shift bezel See: Console Shifter Bezel - Removal.
    3.Remove two screws (8) in the front of the console.
    4.Remove four screws (5) inside the console compartment.
    5.Disconnect console housing wire connector (5) and instrument panel connector (1).
    6.Pull parking brake (3) rearward.
    7.Remove center console (7) from vehicle.
     
  3. Intrepid

    Intrepid Active Member MOTM Winner!

    Joined:
    Jan 11, 2013
    Messages:
    3,156
    Media:
    10
    Likes Received:
    314

Share This Page