[kmurph72]

P0340 code. Found one cam position sensor under the alternator. Not sure if it has another,
code is for sensor A but it is a generic code so who knows.

2008 3.5 R/t 130k

Assuming it has only one cam sensor, replaced the one, replaced the crank sensor. wires look ok. did not pin out the wires yet. what else could I check?

 

[kmurph72]

Further info. Engine was running. suddenly coughed and ran rough for a few minutes. then it lost all power but stayed running for a few minutes. Then it stalled never to start again. when cranking, it sounds normal but will not start. still has a P0340 code.

 

[kmurph72]

Both sensors are Duralast from autozone. The crank sensor took 6 hours to get out. Lots of fun there.